My Humvee jack is set up for vehicles with independent suspension. I modified it using the contact plate of my broken jack. I also left detached so I have the option of using it like it was intended or use it for straight axle vehicles.
Metal fabrication shop located in Merlin Oregon. We specialize in Dodge and Ram truck, repair and modification. From lift kits and suspension to full blown frame off builds. We service and repair all major brands or truck as well as equipment. We offer onsite welding and troubleshooting. We also build headache racks, bed rails and flatbeds.
Friday, April 19, 2013
Monday, April 1, 2013
Jacked
Both my project vehicles have larger tires and sit pretty high off the ground. Due to this and the fact they are both quite heavy most jacks can't lift them. I picked up this new 3.5 ton Hmmwv jack on eBay. It should do the trick!
Wednesday, March 27, 2013
before and after
Here is a before and after of the front end. It wasn't anything to drastic but i think it looks much better and the motor will benefit from the fresh air!
Sunday, March 17, 2013
Grill install part 2
Here it it is installed. I used self tapping screws, they seem to work well everywhere else so I figured I would use them here as well.
Grill install
I finished the grill, primed, painted, mounted, and removed it. I then cut out the center section of the hood. I used one of those vibrating saws that all the hardware stores are pushing. It actually worked pretty good.
Friday, March 15, 2013
Body work
Ole blue has some front end body damage. I am not too worried about the appearance but the grill looks like hell. I did a little redneck modification to it and it looks volumes better. Also the metal loop price was off a Harley, I dug it out of a scrap bin.
Thursday, March 14, 2013
Grillin
Here are the grills. The large one is the upper grill that mounts on top of the hood, the small one mounts behind the existing fiberglass front grill. I used 1.5"x .125" mild steel flat bar and expanded steel . I don't have a shear to cut the expanded steel so I used a grinder and a cut-off wheel.
Subscribe to:
Posts (Atom)













































